Isoparms and Intersections O my!
Isoparms and Intersections O my!
(OP)
I just realized that there are two commands in the sketch toolbar options called face curves and intersection curves. Hurray! Has this feature been here all the while or is it an addition in SWX 2004?
These two commands open up surfacing options and REALLY help with 3D sketches. I played around with them this morning and immediately found it useful in a file that I was struggiling with. Are there any other commands like this for surfacing. Is it possible to view the isoparm curves of the wireframe (ala surfacing programs like Alias and Rhino) in wireframe mode?
These two commands open up surfacing options and REALLY help with 3D sketches. I played around with them this morning and immediately found it useful in a file that I was struggiling with. Are there any other commands like this for surfacing. Is it possible to view the isoparm curves of the wireframe (ala surfacing programs like Alias and Rhino) in wireframe mode?






RE: Isoparms and Intersections O my!
These features have been there since SW2001Plus, I think. They aren't new additions of SW2004.
I hope it can helps.
Marcelo Hendler
RE: Isoparms and Intersections O my!
RE: Isoparms and Intersections O my!
Be naughty - save Santa a trip.
RE: Isoparms and Intersections O my!
But good advice as I do the same.
Ray Reynolds
"There is no reason anyone would want a computer in their home."
Ken Olson, president, chairman and founder of Digital Equipment Corp., 1977
Have you read FAQ731-376 to make the best use of Eng-Tips Forums?
RE: Isoparms and Intersections O my!
1) SW has a Knowledge base to look up particular questions.
2) There are links in our FAQ to help point us to other peoples site that provide information and tips on How to's. There are probably some links form their's as well.
FAQ559-520
3) Our FAQ in general - Lots of good stuff in there now.
Regards,
Scott Baugh, CSWP

http://www.3dvisiontech.com
http://www.scottjbaugh.com
FAQ731-376
RE: Isoparms and Intersections O my!
Read the manuals????......Shame on you.....Red Green & the guys at Possum Lake will disown you.
CorBlimeyLimey
Barrie, Ontario
FAQ559-863
RE: Isoparms and Intersections O my!
RTFM-41
Crashj
RE: Isoparms and Intersections O my!
SnowCrash .... I assume you are being sarcastic
A cover-to-cover read if the instructions can actually be very interesting and informative.
I was - and he did. So at least I didn't get coal.....