Signal transfer from LabView
Signal transfer from LabView
(OP)
Is there a way to establish communication between MatLab and LabView and transfer an ultrasound scanned waveform (acquired in LabView) to MatLab for review and further processing? The signal comes from a National Instruments digitizer (not supported by MatLab) controlled by LabView.
Thank you in advance.
Thank you in advance.





RE: Signal transfer from LabView
http://www.ni.com/analysis/matlab.htm
I don't know if it will help, but it might.
xnuke
Please see FAQ731-376 for tips on how to make the best use of Eng-Tips.