Subtract
Subtract
(OP)
Hi,
In UG NX the subtract command doesn't work with the option
"keep tool" active.
Can anybody give a solution
Thanks
In UG NX the subtract command doesn't work with the option
"keep tool" active.
Can anybody give a solution
Thanks





RE: Subtract
RE: Subtract
RE: Subtract
Try with the option "keep tool" selected and without
selection.
"B" as target and "A" as tool
Thanks
RE: Subtract
Parasolid will NOT allow a tool to be subtracted from the target and leave you with 2 free standing solids.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand
RE: Subtract
"A" and "B" are solid rectangular blocks created in UG NX
"B" will become two blocks if subtracted with "A" when the keep tool is not selected
Subtract failed when "keep tool " is selected.
All other conditions same.
Thanks