hole table
hole table
(OP)
Is it possible when in the draft enviroment to create on hole table, on a seperate page for all of the previous views/pages. For example I am working on a 4 page drawing. I have a front, left , right, and top view. I want to add a page 5 with a hole table for all the previous pages. Any help would be appreciated.
Thank you
Dkdragon
Thank you
Dkdragon





RE: hole table
RE: hole table
RE: hole table
RE: hole table
RE: hole table
-Create the drawing view of the frame on the first sheet
-Temporarily move the drawing view to the sheet you want your hole chart by using the drop down menu on the General tab of the Drawing View Properties
-Drag the drawing view out of the way and create your hole chart as normal
-When the hole chart is complete, use the drop down menu in the Drawing View Properties menu to move the drawing view back to sheet one
-When you need to make revision in the future just make sure to first move the drawing view to the correct drawing sheet used above.
If you have trouble understanding the procedure let me know.
RE: hole table
RE: hole table
Thanks,
DKDragon
RE: hole table
In my case there is not room on the sheet for both the hole chart and the drawing view. That is why the hole charts are on page 2 & 3. I need the drawing view back on page 1 for additional dimensioning.
RE: hole table
I think what RFJ meant was to create a second view on the hole chart sheet identical to view on page one. Then you have view on page one of holes and hole chart on page two linked to second copy of view on page one. That's why file would be larger.
I have used that technique myself to show detail views without having to hve the main view printed. Just keep the main view outside of the drawing sheet area and it doesn't print. Handy for doing assembly instruction sheets.