Syntron Feeder Rehab
Syntron Feeder Rehab
(OP)
I am trying to rehab a 10 yr old limestone milling plant that uses a Syntron Feeder. The most I can get off the nameplate is F-330-C-DT. From the busted up controls, it seems that it is operated at 230VAC etc..
Any advice on how to proceed in terms of sourcing literature, schematics etc.. I have tried FMC but no response..
Any advice on how to proceed in terms of sourcing literature, schematics etc.. I have tried FMC but no response..





RE: Syntron Feeder Rehab
http://www.jmindustrial.com/display.asp?idgroup=4369&ca...
http://equipment.wgint.com/san_roque/crushing/syntronfe...
http://equipment.wgint.com/
http://www.levyindustrial.com/fmc/contactforms/contact....
etc. for more info