Gibbscam service and support feedback
Gibbscam service and support feedback
(OP)
I'm doing much homework looking for an easy to use/ train 2-1/2D CAM program and am liking what I see with Gibbscam.
However, I am getting mixed feddback in regards to service and support. (I seem to hear great things about how well Mastercam is supported)
Does anybody have any service or support expereince they could share about Gibbs and Associates?
Thanks!
However, I am getting mixed feddback in regards to service and support. (I seem to hear great things about how well Mastercam is supported)
Does anybody have any service or support expereince they could share about Gibbs and Associates?
Thanks!





RE: Gibbscam service and support feedback
RE: Gibbscam service and support feedback
RE: Gibbscam service and support feedback
Thanks,
JB
RE: Gibbscam service and support feedback
RE: Gibbscam service and support feedback
RE: Gibbscam service and support feedback
That's interesting because I just spent a couple hours with a demo version and was wondering what I was doing wrong to cause the gouging on tool change. Now I know.
I really like how simple the software feels but I am not a fan of geometry creation, particularly the line termination stuff. Kind of strange. Otherwise it has a lot going for it with th exception of cost.
I also downloaded a demo of Featurecam (among many)and like the geometry creation very much.
Thanks
JB
RE: Gibbscam service and support feedback
RE: Gibbscam service and support feedback
RE: Gibbscam service and support feedback
RE: Gibbscam service and support feedback
As far as Mastercam goes, I used the DOS version(a long time ago) and it was a dinosaur. I have lots of friends that use Mastercam now and prefer it to Gibbs for the geometry creation and ease of surface programming. I guess it'll still work out to personal opinion in the end.
RE: Gibbscam service and support feedback
Have you looked at Featurecam, this software has some potential, in my opinion.