units format
units format
(OP)
I work in LDD. WHen I open my dwg my units are in feet and inches. I then use the -units command to change them to decimal degrees. When I reopen the dwg it reverts back to feet and inches. ANy ideas on how to remedy this annoying problem? thanks





RE: units format
RE: units format
Since we have implimented the changes, we have had no further problems. It will also prevent dimension styles from being automatically (and mysteriously) over-ridden.
RE: units format
are You running 2000/2002? Then try Desktop-> set up drawing-> units
regards Lothar
RE: units format