Drawings
Drawings
(OP)
How can I make a simple can open at one end with a metal rod attached to the side at and angle of 116.5 degrees? Do I create a circle and then extrude? How do I make it open at one end? I just don't know how to go about starting this? Very confused!






RE: Drawings
RE: Drawings
RE: Drawings
Eng-tips doesn't have a space for posting pictures. Sometimes people are able to post things on their own webspace or FTP.
After I get a look, I would be willing to post it on my site for others to see, if that's OK by you.
RE: Drawings