inserting ballons over images
inserting ballons over images
(OP)
I am currently trying to do some photo assemblies and cannot figure out how to insert balloons "On Top" of a digital picture.
Just to clarify, I have inserted a .jpeg file into a SolidWorks "Drawing" file. When I go to "Insert =>Annotations =>Balloon" and then add a balloon to the the picture, if I go to "Print Preview" the .jpeg is always on top of the balloon arrows. Is there a way to make the balloons appear on top of the picture?
Just to clarify, I have inserted a .jpeg file into a SolidWorks "Drawing" file. When I go to "Insert =>Annotations =>Balloon" and then add a balloon to the the picture, if I go to "Print Preview" the .jpeg is always on top of the balloon arrows. Is there a way to make the balloons appear on top of the picture?






RE: inserting ballons over images
You could make it all in a Photoshop image tool and insert the picture into SW. But that kind of defeats the purpose of SW other than the border.
Regards,
Scott Baugh, CSWP

3DVision Technologies
http://www.3dvisiontech.com
http://www.scottjbaugh.com
FAQ731-376
When in doubt, always check the help
RE: inserting ballons over images
3/4 of all the Spam produced goes to Hawaii - shame that's not true of SPAM also.......