Helix mates
Helix mates
(OP)
Hi,
I have a horizontal screw drive that i'm designing and it utilizes a helix for the thread, how do i mate the two threaded parts? (using SW2003)
I have a horizontal screw drive that i'm designing and it utilizes a helix for the thread, how do i mate the two threaded parts? (using SW2003)






RE: Helix mates
Regards,
Scott Baugh, CSWP

3DVision Technologies
http://www.3dvisiontech.com
http://www.scottjbaugh.com
FAQ731-376
When in doubt, always check the help