Font size of BOM column header
Font size of BOM column header
(OP)
I can't seem to get Solidworks to accept different font size for the column headers in the BOM. In Excel I can set font size in the headers to 6 and the body to 10, but SolidWorks reverts them all to 6 when inserted, and trashes some of the justifications as well. Any thoughts?






RE: Font size of BOM column header
I can only echo your pain and return it fivefold. It would be really nice to see more carryover from Excel into the BOM.
Case in point: yesterday's thread about adding blank space to the BOM. It would have been nice to be able to arry over Excel cell borders.
I would also like to see the ability to use a different font for headers, and have cell formats carry over.
RE: Font size of BOM column header
A lot of these Excel BOM problems are going to go away in SW04. But I wonder how many new problems are going to arise?
Regards,
Scott Baugh, CSWP

3DVision Technologies
http://www.3dvisiontech.com
http://www.scottjbaugh.com
FAQ731-376
When in doubt, always check the help
RE: Font size of BOM column header