Planes 1,2 & 3
Planes 1,2 & 3
(OP)
Greetings to all.
I am aware that once a plane has been "autosized" the plane will always be 5% larger than the associated geometry or bounding box.
Here is the question.
Is there a way to have the autosize activated for all new parts or existing parts for that matter? I have highlighted all three, RC and pick autosize. Only the last selected plane is autosized. This is small issue quickly becoming a pain in the back side. I would like the autosize option to be actieve by default.
Thanks to all
Jesus is the WAY the TRUTH and the LIFE,
Jay
I am aware that once a plane has been "autosized" the plane will always be 5% larger than the associated geometry or bounding box.
Here is the question.
Is there a way to have the autosize activated for all new parts or existing parts for that matter? I have highlighted all three, RC and pick autosize. Only the last selected plane is autosized. This is small issue quickly becoming a pain in the back side. I would like the autosize option to be actieve by default.
Thanks to all
Jesus is the WAY the TRUTH and the LIFE,
Jay






RE: Planes 1,2 & 3
Regards,
Scott Baugh, CSWP

3DVision Technologies
http://www.3dvisiontech.com
http://www.scottjbaugh.com
FAQ731-376
When in doubt, always check the help
RE: Planes 1,2 & 3
Thanks,
Jay