How to Dimension in sketch
How to Dimension in sketch
(OP)
if i sketch an oval slot, how do you dimension to the outer tangent edges.
it always wants to dimension to the centers
it always wants to dimension to the centers
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS Come Join Us!Are you an
Engineering professional? Join Eng-Tips Forums!
*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail. Posting GuidelinesJobs |
How to Dimension in sketch
|
RE: How to Dimension in sketch
When you select the arcs of the slot, make sure you do not pick a control point, but try to select near the side where you want the dimension placed.
--Scott
For some pleasure reading, the Round Table recommends FAQ731-376