mazak cutting conditions please
mazak cutting conditions please
(OP)
Hi can anyone send me cutting conditions and tips for cutting 10 mm and 12 mm mild steel as the lad that runs our laser has left at short notice and thrown me in at the deep end (i must keep that red light flashing)and am having a few problems (bad finishes) i am running a mazak 1500w x48 champion loads of thanks
Harvey
Harvey





RE: mazak cutting conditions please
Good Luck
(0.375 HRS FAST)
(STANDARD FOCUS)
(0.077 NOZZLE)
G82P1500Q50R20M69
G88P6M56
G87P0
M32
M20
M22
G04X1.0
G82P1500Q100R26M69
G04X1.5
G82P1500Q150R33M69
G04X1.5
G82P1500Q200R40M69
G04X3.5
G82P1500Q700R100M69F35.0
G88P5M56
G87P15
G04X0.5
M99
:9062
(0.500 HRS)
(STANDARD FOCUS)
(0.077 NOZZLE)
G82P1500Q25R17M69
G88P5M56
G87P0
M32
M20
M22
G04X0.5
G82P1500Q30R20M69
G04X0.5
G82P1500Q40R25M69
G04X0.5
G82P1500Q50R30M69
G04X1.0
G82P1500Q60R35M69
G04X1.0
G82P1500Q70R40M69
G04X1.5
G82P1500Q80R43M69
G04X2.0
G82P1500Q90R46M69
G04X2.5
G82P1500Q100R48M69
G04X4.0
G82P1500Q100R100M69F28.0
G88P6M56
G87P15
G04X0.5
M99
RE: mazak cutting conditions please
harvey shawsy81@hotmail.com