PRO/E to SW
PRO/E to SW
(OP)
Need some advice. I have a PRO/E model that I was sure we could convert to SW 2003. When I attempt to convert I get the message "...download and install the PRO/E decrypter from the SW subscription Support website."
I've had no luck. Any suggestions?
I've had no luck. Any suggestions?






RE: PRO/E to SW
RE: PRO/E to SW
Regards,
Scott Baugh, CSWP

3DVision Technologies
http://www.3dvisiontech.com
http://www.scottjbaugh.com
FAQ731-376
When in doubt, always check the help
RE: PRO/E to SW
I found that Solidworks 2004 is able to translate ProE files better than SW2003. If you have a licence please give it a try.
Regards,
Emil
RE: PRO/E to SW
Pro-E got to be their usual egotistical, greeedy, prima donna, selfish, b..t hole selves and wanted many times what it is worth for a "licence" to decrypt their databases. So SW understandably told them to go to you know where.
In a CAD world that demands more and more open databases, common formats and file sharing, it is amazing how neantherthal Pro_E can be, but then if you recruit use car sales men what do you expect? No wonder the company is going down the tubes. It is sad to see, but they have make every clssic "big" CAD company mistake possible over the years - you would think they would look at and pay attention to the history of the business.
OK - I'm fine now......
I was - and he did. So at least I didn't get coal.....
OK, OK, It's a reference to my holiday sig. "Be naughty - Save Santa a trip..."
RE: PRO/E to SW
- - -Dennyd
RE: PRO/E to SW
Regards,
Scott Baugh, CSWP

http://www.3dvisiontech.com
http://www.scottjbaugh.com
FAQ731-376