Is TRL calibration with 8753C VNA possible?
Is TRL calibration with 8753C VNA possible?
(OP)
Hello,
i tried to figure out if it is possible to perform a TRL calibration with the 8735C VNA (HP - Agilent). In the net i found some papers that mention that it is possible. But i didn't succeeded in implementing a TRL routine in the 8753C yet. Has anyone experiences with this problem?
Thank's in advance
i tried to figure out if it is possible to perform a TRL calibration with the 8735C VNA (HP - Agilent). In the net i found some papers that mention that it is possible. But i didn't succeeded in implementing a TRL routine in the 8753C yet. Has anyone experiences with this problem?
Thank's in advance





RE: Is TRL calibration with 8753C VNA possible?
Barry
RE: Is TRL calibration with 8753C VNA possible?
Propably there is no easy and cheap firmware update for TRL cal available? Even though it is "just" software
I think i will do the correction computation manually with a mathematic program in an computer. That'll be much more easy than transfering the calibration code to the VNA.
Best regards