Re-orient part?
Re-orient part?
(OP)
I added a tab and then two bends to my drawing. Everything looks ok but now my drawing is standing on it's nose. Is there any way to re-orient it so it's is viewed properly. It makes things confusing to keep it that way.
Dave
Dave






RE: Re-orient part?
Best Regards,
Scott Baugh, CSWP

3DVision Technologies
http://www.3dvisiontech.com
http://www.scottjbaugh.com
FAQ731-376
When in doubt, always check the help
RE: Re-orient part?
Mr. Pickles
RE: Re-orient part?