defining fn keys (eg. F12)
defining fn keys (eg. F12)
(OP)
I am looking for a script that will allow me to program my "F12" key to pull up a program like microsoft calculator
Anyone out there accomplished this yet?
Anyone out there accomplished this yet?





RE: defining fn keys (eg. F12)
Just make sure the properties say the following ....
^C^C_shell;calc.exe;
But if you wish to assign the F12 key this function then just write it the same under the ACAD.mnu file under the accelerators section for F12.
Here's a link to thread which had some discussion on re-programming the "F" keys.
Best of luck!
Thread555-46166