Missing "+"
Missing "+"
(OP)
When I specify a "0" for an upper or lower tolerance, Wildfire omits the sign in front of it. It will show a "+" or a "-" in front of the tolerance with a value other than "0". I want to see both signs. Is there some setting to change this? Thanks.
Don
BCF Technology
Mohawk Industries





RE: Missing "+"
Reference figure 2.2 on page 24 of ASME Y14.5-1994 manual.
Also look at section 2.3 on page 24.
For imperial unit parts , then it should give the +0 or -0.
Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand
RE: Missing "+"
Don
BCF Technology
Mohawk Industries