Photoworks materials?
Photoworks materials?
(OP)
After upgrading to SW 2003, I cannot seem to get surfaces to display their PhotoWorks colors in my SW window. Also, when I render, the properties are not applied to my surfaces like they were in SW 2001.
Am I missing a setting somewhere? Normally I'll pick selected surfaces and texture them differently just like I would a normal injection-molded part. PW lets me do this, but doesn't display the results--neither in the rendering nor the SW window.
I have not yet installed any SPs, so am still at 0.0. Also, I have the "overwrite SW properties for render" on and the other option off. Any ideas?
Am I missing a setting somewhere? Normally I'll pick selected surfaces and texture them differently just like I would a normal injection-molded part. PW lets me do this, but doesn't display the results--neither in the rendering nor the SW window.
I have not yet installed any SPs, so am still at 0.0. Also, I have the "overwrite SW properties for render" on and the other option off. Any ideas?
Jeff Mowry
DesignHaus Industrial Design
http://www.designhaus-i-d.com






RE: Photoworks materials?
RE: Photoworks materials?
Thanks a ton! I don't know how I would have guessed that.
Jeff Mowry
DesignHaus Industrial Design
http://www.designhaus-i-d.com