PCP Pumps
PCP Pumps
(OP)
We have shallow oil wells in Kyrgystan ( 100-170 m depth); Low pressure, low rates.Would someone help me in locating manufacturers/ suppliers, they can design and install.Furthermore where can I get more information as to their utility, efficiency, design, etc.





RE: PCP Pumps
Schlumberger, Weatherford and Baker all offer PCP's.
I found this site that may help with a little information.
http://nsol.ab.ca/pcp/Overview.html
Good Luck!
RE: PCP Pumps
Numerous manufacturers and suplidores of PCP exist, most of them can make the design and installation, nevertheless I recommend to you that you must participate in the design, since they know their equipment, but
you know your wells.
It is important that you provide with exactitude the bottom hole data, is to say: pressure, temperature, viscosity, oil gas relation, water cut, etc. as well as the rate that you expect to produce, characteristics from wells like total depth, depth of the perforations, type of
well: vertical, deviated or horizontal, casing diameter, tubing diameter, well head pressure, etc.
RE: PCP Pumps
Go to http://www.centrilift.com/PCPS/default.htm
There is plenty of information there.
If you need anything specific let me know.
All the best
RE: PCP Pumps
I'm a production engineer, specialist in artifical lift, so i can help you, that if you wish. You can write to me in the next electronic address carlos.a.figueroa@petrozuata.com.
regards.
RE: PCP Pumps
http://www.slb.com/oilfield/index.cfm?id=id1430586
enjoy!