Dimension color in drawing?
Dimension color in drawing?
(OP)
Where do I go to set the color of my dimensions for drawings?
They were originally black, then they were light grey (printed OK on paper but were light in .PDF's) and now that I have upgraded to SW2003 my dimensions are light blue. I would really like to have black dimensions again.
Thanks
They were originally black, then they were light grey (printed OK on paper but were light in .PDF's) and now that I have upgraded to SW2003 my dimensions are light blue. I would really like to have black dimensions again.
Thanks






RE: Dimension color in drawing?
I hope that helps,
Scott Baugh, CSWP

3DVision Technologies
credence69@REMOVEhotmail.com
http://www.3dvisiontech.com
http://www.3dmca.com
*When in doubt, always check the help*
RE: Dimension color in drawing?
Imported Annotations Driven was what I need to change.