BOM Sorting
BOM Sorting
(OP)
Hi All:
I am have sorted my bom in a alpha numeric order, because of my patterns I guess it does not show the order the same as my design tree.
I do not want to sort manually because this causes me to sort every time a new part is added.
Is there a way to play with the patterns so they are read last in a bom?
thanks for reading
-Caper-
I am have sorted my bom in a alpha numeric order, because of my patterns I guess it does not show the order the same as my design tree.
I do not want to sort manually because this causes me to sort every time a new part is added.
Is there a way to play with the patterns so they are read last in a bom?
thanks for reading
-Caper-






RE: BOM Sorting
Regards,
Scott Baugh, CSWP

3DVision Technologies
credence69@REMOVEhotmail.com
http://www.3dvisiontech.com
http://www.3dmca.com
*When in doubt always check the help*
RE: BOM Sorting
If only I could do my patterns last everything would be fine but I do not have a chrystal ball on my desk.
I can reorder the parts but and I can reorder the patterns but reordering patterns does not effect the order of the BOM.
-Caper-
RE: BOM Sorting
BBJT CSWP
RE: BOM Sorting
RE: BOM Sorting
RE: BOM Sorting
The only thing that really works is removing the D part out of the B/D pattern and adding another pattern to replace it. This is a PITA but it does not take all that long. The order of the patterns in the Design Table does not seem to matter.
Lee