Modeling two plates that are stacked
Modeling two plates that are stacked
(OP)
Hi,
I posted a thread in the FEM forum. It has to do with designing a Sole Plate that goes between a bridge steel plate girder and the elastomeric (steel reinforced) bearing pad. Here's a link:
Thread727-44756 I would appreciate it if anyone would check out the thread and respond there.
Thanks, Randy
I posted a thread in the FEM forum. It has to do with designing a Sole Plate that goes between a bridge steel plate girder and the elastomeric (steel reinforced) bearing pad. Here's a link:
Thread727-44756 I would appreciate it if anyone would check out the thread and respond there.
Thanks, Randy





