ASME Sec. VIII - Pressure Vessel Design - Stiffener ring for Nozzle neck.
ASME Sec. VIII - Pressure Vessel Design - Stiffener ring for Nozzle neck.
(OP)
i need to design boot for Pressure vessel using PVElite,
So i design the boot as nozzle and instead of flange i put dished end.
My concern is since the boot height is very large i need to provide stiffener ring (minimum two no.).
Anyone please advise me how to insert this stiffening ring for this boot (Nozzle neck) in PVElite.
So i design the boot as nozzle and instead of flange i put dished end.
My concern is since the boot height is very large i need to provide stiffener ring (minimum two no.).
Anyone please advise me how to insert this stiffening ring for this boot (Nozzle neck) in PVElite.




