Cannot see Section in NX 9
Cannot see Section in NX 9
(OP)
I am creating some views in a drawing and when I go to create a section I'm not seeing it. I'm not even seeing the borders.
So I tried a different print template I have. This time I am seeing the border of the section view but am not seeing the actual section. I've attached screenshot of the tree/error message and highlighted what I see when I do attempt to create the section. This is NX 9. Anybody have any ideas?
So I tried a different print template I have. This time I am seeing the border of the section view but am not seeing the actual section. I've attached screenshot of the tree/error message and highlighted what I see when I do attempt to create the section. This is NX 9. Anybody have any ideas?





RE: Cannot see Section in NX 9
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
Building new PLM environment from Scratch using NX11 / TC11