NX Drafting Reset
NX Drafting Reset
(OP)
Hi,
I clicked accidentally a button or key or key combination in NX 8.0 drafting. Now NX don't generating
a section view any more. Is there a chance to reset (to default) the drafting module?
Thx
I clicked accidentally a button or key or key combination in NX 8.0 drafting. Now NX don't generating
a section view any more. Is there a chance to reset (to default) the drafting module?
Thx





RE: NX Drafting Reset
I am not aware of any setting which can switch off section views.
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
Building new PLM environment from Scratch using NX11 / TC11
RE: NX Drafting Reset
As Ronald says, this sounds strange.
But, in some rare situations we will encounter either models which cannot be sectioned due to "data corruption" or placement of the section cut which cannot be computed.
Regards,
Tomas
RE: NX Drafting Reset
John Joyce
Manufacturing Engineer
Senior Aerospace CT
NX 10 & 11.0.1 Vericut 8.0.3
RE: NX Drafting Reset
www.nxjournaling.com
RE: NX Drafting Reset
RE: NX Drafting Reset
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
Building new PLM environment from Scratch using NX11 / TC11
RE: NX Drafting Reset
Back to the topic: It was the Role! I clicked maybe a key combination, changing my role to a useless one.So joycejo send me the solution.
Thanks to all.
Bogdan