Vessel cleat/clip design
Vessel cleat/clip design
(OP)
Hi,
A colleague of mine is designing a pressure vessel and came across the following design concern: He needs to model a support for a load of 60kN and needs to design a vessel clip/cleat for attachment.
So the question is this, is there any standard or software pertaining to this issue (he needs to design the cleat)? He already tried modelling it on PVElite as a vessel clip but ran into some issues there.
A colleague of mine is designing a pressure vessel and came across the following design concern: He needs to model a support for a load of 60kN and needs to design a vessel clip/cleat for attachment.
So the question is this, is there any standard or software pertaining to this issue (he needs to design the cleat)? He already tried modelling it on PVElite as a vessel clip but ran into some issues there.





RE: Vessel cleat/clip design
RE: Vessel cleat/clip design
Forget PVE, just use the Codecalc portion to design the clip itself, and attachment to the shell per WRC 107.
Regards,
Mike
The problem with sloppy work is that the supply FAR EXCEEDS the demand
RE: Vessel cleat/clip design
SnTMan- he is interested in both.
Much appreciated