Steel Suppier Quality Question
Steel Suppier Quality Question
(OP)
Does anybody on the board have any direct or indirect experience of the quality of steel produced by Moravia Steel (formerly the Poldi Steel Complex) in the Czech Republic?
I am looking for a source of alloy steel material ( Cr,Mo - Ni,C, Mo type compostions), approaching bearing quality, in bar form from 125 mm up to 250 mm diameter.
Don't want to transgress the board rules about commercial activities - but I would like to pick some brains before I decide to travel several thousand kms to check them out!
I am looking for a source of alloy steel material ( Cr,Mo - Ni,C, Mo type compostions), approaching bearing quality, in bar form from 125 mm up to 250 mm diameter.
Don't want to transgress the board rules about commercial activities - but I would like to pick some brains before I decide to travel several thousand kms to check them out!





RE: Steel Suppier Quality Question
RE: Steel Suppier Quality Question
RE: Steel Suppier Quality Question
RE: Steel Suppier Quality Question
RE: Steel Suppier Quality Question
Bear in mind that what you get as a one-off sample won't necessarily match the product. I'm not saying that these guys are like this, but I'm sure we've all met this problem somewhere along the line.