Rivnut specs ?
Rivnut specs ?
(OP)
Hi guys,
We're looking to use BN330-1032 rivnuts (not MS27130 or similar) but can't find specs for them. Any ideas ?
These guys have a much thicker wall than the MS (for a #10 screw the BNs are 0.3" dia, and the MS are 0.25").
We're looking to use BN330-1032 rivnuts (not MS27130 or similar) but can't find specs for them. Any ideas ?
These guys have a much thicker wall than the MS (for a #10 screw the BNs are 0.3" dia, and the MS are 0.25").
another day in paradise, or is paradise one day closer ?





RE: Rivnut specs ?
I found this: http://ginengineers.com/pdf/rivnut.pdf
Perhaps it helps. I thought rivnuts have gone out of favor due to spinning, stress concentration due to the knurl, etc. I still like them and have installed them on my boat.
RE: Rivnut specs ?
another day in paradise, or is paradise one day closer ?
RE: Rivnut specs ?
I think BN330* is a LISI part... however I did not find a spec for BN330 directly in their on-line data.
Suggest calling LISI for the specifics for BN330-* [TDS, allowables, etc].
http://www.lisi-aerospace.com/products/fasteners/b...
http://jet-tek.com/aerospace-fasteners/blind-faste...
What about NAS1734, NAS1735 Installed per NAS1736 Elliptical Blind Nuts...?? These are all-over F-16 wings [or were]
What about FTI...
Force-Tec Rivetless Nut Plates http://www.fatiguetech.com/products-forcetec-class...
TucLok Blind Fastening System http://www.fatiguetech.com/products-tukloc.asp
Regards, Wil Taylor
o Trust - But Verify!
o We believe to be true what we prefer to be true. [Unknown]
o For those who believe, no proof is required; for those who cannot believe, no proof is possible. [variation,Stuart Chase]
o Unfortunately, in science what You 'believe' is irrelevant. ["Orion", Homebuiltairplanes.com forum]
RE: Rivnut specs ?
more info ... BN330 is the sleeve, BN360 is the sleeve and nut combo.
another day in paradise, or is paradise one day closer ?