Presentation Video Part Callout/Identification
Presentation Video Part Callout/Identification
(OP)
I'm very new to Inventor and we are primarily using models and assemblies to make assembly videos of the parts. Is there a way to show the ID of each part as it is assembled?
My apologies for being a newb but trying to learn.
Thanks ~ Jim
My apologies for being a newb but trying to learn.
Thanks ~ Jim
Jim Weisner
Senior Designer
General Electric Company





RE: Presentation Video Part Callout/Identification
Never seen that done with Inventor.
Can you do it post-rendering with your video-editing software?
STF