Turn Off Continuous Auto Dimensioning
Turn Off Continuous Auto Dimensioning
(OP)
Greetings,
I sketch quite a bit for a lot of our work. When opening a new session of UG NX9, the Preferences - Sketch - Continuous Auto Dimensioning is always checked. Is there a way to change this setting so that it is off even if I open a new session?
Thanks for your help in advance.
Brent
I sketch quite a bit for a lot of our work. When opening a new session of UG NX9, the Preferences - Sketch - Continuous Auto Dimensioning is always checked. Is there a way to change this setting so that it is off even if I open a new session?
Thanks for your help in advance.
Brent





RE: Turn Off Continuous Auto Dimensioning
www.nxjournaling.com
RE: Turn Off Continuous Auto Dimensioning