Meshing with Partition for boundary conditions
Meshing with Partition for boundary conditions
(OP)
thread799-375540: Mesh error in Abaqus 6.13
I have the partition at the edges of the model shown below to be able to apply boundary conditions to it (simulate jaws in a tensile test). These partition faces are not allowing me to mesh my sample. I used virtual topology, but that removes the BCs.
Please help, I am new to Abaqus!
I have the partition at the edges of the model shown below to be able to apply boundary conditions to it (simulate jaws in a tensile test). These partition faces are not allowing me to mesh my sample. I used virtual topology, but that removes the BCs.
Please help, I am new to Abaqus!





RE: Meshing with Partition for boundary conditions
RE: Meshing with Partition for boundary conditions
Thank you for your response.
I have created the partition encircled in red to be able to apply boundary conditions which represent the grips of a hydraulic testing machine (the specimen is gripped at the grips at both ends and a tensile load is applied as the actuator moves).