Huth Formula for Fastener Flexibility - "optimum" plates thickness
Huth Formula for Fastener Flexibility - "optimum" plates thickness
(OP)
In relation to an old thread
http://www.eng-tips.com/viewthread.cfm?qid=338665
Am I correct to say that there is a "optimum" thickness ratio (t2 = 1.5*t according to my plot) where the shear stiffness calculated using Huth formula is maximum?
While doing a sensitivity study (frequency) I came to realised that the "key" frequency could only come down (marginally but still!)
http://www.eng-tips.com/viewthread.cfm?qid=338665
Am I correct to say that there is a "optimum" thickness ratio (t2 = 1.5*t according to my plot) where the shear stiffness calculated using Huth formula is maximum?
While doing a sensitivity study (frequency) I came to realised that the "key" frequency could only come down (marginally but still!)




