DIMENSIONS ON CAST PART DRAWINGS
DIMENSIONS ON CAST PART DRAWINGS
(OP)
I have never worked with cast parts before until now and learned nothing about them in school. Is it proper to call out the draft angle on the drawing or do you let the people molding the part decide what is sufficient? Also, how would I go about specifying a surface finish for a cast part?
Thanks
Thanks





RE: DIMENSIONS ON CAST PART DRAWINGS
thread1103-425635: Casting and molded draft embedded in the solid model
RE: DIMENSIONS ON CAST PART DRAWINGS
RE: DIMENSIONS ON CAST PART DRAWINGS
What is your company's policy? What would your vendor like you to do?
--
JHG
RE: DIMENSIONS ON CAST PART DRAWINGS