CATDrawing geometry identification and merging
CATDrawing geometry identification and merging
(OP)
Hi,
I'm looking for a function in CATIA V5 that identifies the geometries on a drawing (as viewed in the attached image, an example of top view).

I want to write a macro to identify and merge the edges.
Thanks in advance,
Portolon
I'm looking for a function in CATIA V5 that identifies the geometries on a drawing (as viewed in the attached image, an example of top view).

I want to write a macro to identify and merge the edges.
Thanks in advance,
Portolon





RE: CATDrawing geometry identification and merging
Did you checked the view properties? Maybe is something there which can help you...
Regards
Fernando
https://picasaweb.google.com/102257836106335725208 - Romania
https://picasaweb.google.com/103462806772634246699... - EU
RE: CATDrawing geometry identification and merging
Thanks for answering.
I looked at properties, but I didn't find information about type (edge x non-edge).