How to give AC current source in ANSYS Workbench
How to give AC current source in ANSYS Workbench
(OP)
I wanna analysis "spot welding" by workbench , it's must provide Alternating current(AC)of 1.0kA is applied with 14 cycles at a frequency of 50 Hz during 0.3sec. How to set up ? How to write the Commands?
What's wrong with the following? And how to write Alternating current(AC)of 1.0kA is applied with 14 cycles at a frequency of 50 Hz during 0.3sec ?
Iamp=1000
pha=30
*afun,deg
What's wrong with the following? And how to write Alternating current(AC)of 1.0kA is applied with 14 cycles at a frequency of 50 Hz during 0.3sec ?
Iamp=1000
pha=30
*afun,deg




