NXOpen motion simulation
NXOpen motion simulation
(OP)
Hello all,
I have requirements in motion simulation automation.
1. Need to iterate through joint drivers and suppress/unsuppress required drivers in NXOpen .Net.
2. Enable selection of joint drivers using NXOpen .Net.
Any suggestions or samples on this.
Thanks,
Hariharan B
I have requirements in motion simulation automation.
1. Need to iterate through joint drivers and suppress/unsuppress required drivers in NXOpen .Net.
2. Enable selection of joint drivers using NXOpen .Net.
Any suggestions or samples on this.
Thanks,
Hariharan B




