Design of saddle
Design of saddle
(OP)
Hi Guys
I need to verify two saddle according to ASME Sec III NF. The idea is verify the saddle by fea (Design by analysis) (I already have a fea model of the pressure vessel with its supports) and on the other hand, verify the supports with design by rule according to ASME Sec III.
The saddle supports are class 1.
Any idea?
Thank a lot!!!
I need to verify two saddle according to ASME Sec III NF. The idea is verify the saddle by fea (Design by analysis) (I already have a fea model of the pressure vessel with its supports) and on the other hand, verify the supports with design by rule according to ASME Sec III.
The saddle supports are class 1.
Any idea?
Thank a lot!!!





RE: Design of saddle
RE: Design of saddle
RE: Design of saddle