Drawing tab issue Drawing tab issue sandy JA (Mechanical) (OP) 17 Apr 17 16:27 Hi all Good Day! I have one issue with mu colleague system. When opening a new file command Drawing tab is not visible for him. Attached the image for reference with drawing tab. RE: Drawing tab issue MikeHalloran (Mechanical) 18 Apr 17 00:26 Try again to attach the image. Mike Halloran Pembroke Pines, FL, USA RE: Drawing tab issue 3DDave (Aerospace) 18 Apr 17 04:52 This question should be asked in the forum for the software that is used. RE: Drawing tab issue sandy JA (Mechanical) (OP) 18 Apr 17 08:59 Thanks Dave I will try. Hi Mike I have attached the image with drawing tab. http://files.engineering.com/getfile.aspx?folder=42281010-a2c6-46a0-a101-4d RE: Drawing tab issue moon161 (Mechanical) 27 Apr 17 03:42 Try posting here in the UG/NX forum http://www.eng-tips.com/threadminder.cfm?pid=561 Mark this thread for deletion.