bridge crane / travelling monorail
bridge crane / travelling monorail
(OP)
I've designed monorail before where the monorail top flange is bolted to a supporting beam bottom flange and the hoist is the only thing moving back and forth.
I need to have this monorail move left-right similar to a bridge crane.
do you know what kind of roller type connection is should use to connect the top flange of monorail to bottom flange of supporting beam
I need to have this monorail move left-right similar to a bridge crane.
do you know what kind of roller type connection is should use to connect the top flange of monorail to bottom flange of supporting beam






RE: bridge crane / travelling monorail
It seems to me that your Sec. A-A is wrong. You need the red trolley beam so the basic hoist can travel north-n-south, similar to what you say you’ve done in the past. But, this is a fairly long beam with no compression flg. lateral support, so be careful. Then, at the ends of this red trolley beam, you need another set of underhung trolley rollers (wheels, trucks, whatever) not unlike the rollers for your basic hoist trolley, but heavier, so the system can travel east-n-west. And, here you have to be careful that the two end trucks run in unison so the whole moving bridge (red trolley beam) can’t skew w.r.t. its tracks on the bldg. beam lines.
RE: bridge crane / travelling monorail
RE: bridge crane / travelling monorail
Dave
Thaidavid