Hello All! I would like to make
Hello All! I would like to make
(OP)
Hello All!
I would like to make a 2D drawing from a similar part (assy) like this below and put GD&T symbols and datum features on it.
I need alot of tips how to do? My problem is the flexi and the tube ends.
http://www.pumaspeed.co.uk/product-Milltek-Sport-F...
Regards
Gerre
I would like to make a 2D drawing from a similar part (assy) like this below and put GD&T symbols and datum features on it.
I need alot of tips how to do? My problem is the flexi and the tube ends.
http://www.pumaspeed.co.uk/product-Milltek-Sport-F...
Regards
Gerre





RE: Hello All! I would like to make
I would start by viewing the above.