NX11 basic curves
NX11 basic curves
(OP)
Is Siemens officially, once and for all, removing the Basic Curves functionality from NX? Ihave heard this but I still can launch Basic Curves with command finder.
Just wondering, perhaps the KEEP IT public sentiment was heard? :)
Just wondering, perhaps the KEEP IT public sentiment was heard? :)





RE: NX11 basic curves
John R. Baker, P.E. (ret)
EX-Product 'Evangelist'
Irvine, CA
Siemens PLM:
UG/NX Museum:
The secret of life is not finding someone to live with
It's finding someone you can't live without