UGNX 3.0.5.3 Maintenance release
UGNX 3.0.5.3 Maintenance release
(OP)
Hello,
I am still running NX Version 3. I know it is old ! I was wondering if anyone had maintenance release 3.0.5.3 they could send me.
I finally upgraded from XP to Windows 7 and apparently this maintenance release fixes the graphics error I get?
Thanks !
I am still running NX Version 3. I know it is old ! I was wondering if anyone had maintenance release 3.0.5.3 they could send me.
I finally upgraded from XP to Windows 7 and apparently this maintenance release fixes the graphics error I get?
Thanks !





RE: UGNX 3.0.5.3 Maintenance release
If you have a legit version of NX then you can also get a webkey...
With that you can download it for free.
I don't think anyone here will provide you that update without knowing if you have a legal version of NX
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
Building new PLM environment from Scratch using NX11 / TC11
RE: UGNX 3.0.5.3 Maintenance release
John R. Baker, P.E. (ret)
EX-Product 'Evangelist'
Irvine, CA
Siemens PLM:
UG/NX Museum:
The secret of life is not finding someone to live with
It's finding someone you can't live without
RE: UGNX 3.0.5.3 Maintenance release
Mark Rief
NX CAM Customer Success
Siemens PLM Software
RE: UGNX 3.0.5.3 Maintenance release
I believe I would need to be paying maintenance in order to get a web key.
I could back pay the maintenance, however, the cost would be too much.
Thanks again for the advice.