DimExpert for Tol Analysis
DimExpert for Tol Analysis
(OP)
Anyone have any luck understanding the SW help on creating a Tolerance analysis using the DimExpert? I am have been reading into this, this morning... it just seems like A LOT of work for something that I could easily just grab all the dimensions that are already in the model and figure my Tolerance using Excel. Thought I would give SW a try in this department, but it seems thrown together. Any advice?
Any help making sense of DimExpert is appreciated. The help hasn't been all that much of any help.
Thanks,
Any help making sense of DimExpert is appreciated. The help hasn't been all that much of any help.
Thanks,
Scott Baugh, CSWP 
Gryphon Environmental
www.2gryphon.com
FAQ731-376: Eng-Tips.com Forum PoliciesQuote:
"If it's not broke, Don't fix it!"





