I am running a FSI simulation. The radius of the fluid inlet changes every time step based on the deformation. The velocity profile at the inlet is based on this area and it changes every time step. Is there a way to measure the radius of inlet using a UDF?
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
PCB design is a purposeful process. In essence, every PCB design is a complex puzzle that requires a designer to incorporate critical components and tight schematics into a piece of technology that is governed by rules, constraints and industry standards. Download Now