On MSS SP-75 Section 13.5 it talks about Segmentable Elbows. My question is if it is a Spec requirement for ALL High Yield Elbows (LR, 3R, 90 degrees, 45 degrees and 180 grees) to be Segmentable or does the purchaser have to request them to be Segmantable on the Purchase Order. Also is the Segmentable only for Elbow sizes 16 inches and up or does it apply to smaller elbows as well?
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
PCB design is a purposeful process. In essence, every PCB design is a complex puzzle that requires a designer to incorporate critical components and tight schematics into a piece of technology that is governed by rules, constraints and industry standards. Download Now