NX-Electrical routing, terminals on added part in assembly invisible, visible in part design only
NX-Electrical routing, terminals on added part in assembly invisible, visible in part design only
(OP)
Hi Community,
now is start recently with electrical design in NX8.0. I made my first socket and added the first 5 terminals, visible as lines and arrows.
But visible only in PART DESIGN not when I loaded the part to an ASSEMBLY. Parts and Assemblies are in electrical routing modus.
I started an new assembly added the fresh designed socket - and bad surprise: no terminal symbols visible.
Maybe I touched accidently a wrong button or created a key combination.
See attached images. Maybe one of you know the reason and can help me.
Thanks
now is start recently with electrical design in NX8.0. I made my first socket and added the first 5 terminals, visible as lines and arrows.
But visible only in PART DESIGN not when I loaded the part to an ASSEMBLY. Parts and Assemblies are in electrical routing modus.
I started an new assembly added the fresh designed socket - and bad surprise: no terminal symbols visible.
Maybe I touched accidently a wrong button or created a key combination.
See attached images. Maybe one of you know the reason and can help me.
Thanks




