g codes
g codes
(OP)
Hi does anyone know if there is a g code to make a amada 3015 fo laser change shuttle beds and re-start the programme automatically .I get a lot of long running sheets that ill like to run during the knight with minimal supervision .





RE: g codes
What shuttle table do you have? And are you using Dr.Abe for nesting?
RE: g codes
RE: g codes
M707 to shuttle, M97 repeats the same program on table #2.
There are ways to run a different program on table #2 but it's a little complicated if you have an NT machine.
RE: g codes