NX 9 CAM Kinematic Problem
NX 9 CAM Kinematic Problem
(OP)
Hello Community,
My kinematic aspect is quite difficult. I have two rotation axis and a single translatory movement of my tool in direction of my blank rotation axis (feed/pitch). My blank has his own rotation axis like in turning operation but my tool has an other rotation axis as the blank.
I hope you can understand my explanation of the kinematic. In which operation can i get such a kinematic in NX?
Thank You.
Sincerly
Rick
My kinematic aspect is quite difficult. I have two rotation axis and a single translatory movement of my tool in direction of my blank rotation axis (feed/pitch). My blank has his own rotation axis like in turning operation but my tool has an other rotation axis as the blank.
I hope you can understand my explanation of the kinematic. In which operation can i get such a kinematic in NX?
Thank You.
Sincerly
Rick





RE: NX 9 CAM Kinematic Problem
Are you asking about machine simulation?
Mark Rief
NX CAM Customer Success
Siemens PLM Software
RE: NX 9 CAM Kinematic Problem
RE: NX 9 CAM Kinematic Problem
thank you.
RE: NX 9 CAM Kinematic Problem
Mark Rief
NX CAM Customer Success
Siemens PLM Software
RE: NX 9 CAM Kinematic Problem
I have now already a model, but can't insert my kinematic for 100%.
I created the operation "multi-axis-mill" and the custom operation "Generic Motion". I am able to move my tool along a point vector combination.
My problem now is that i just can insert point vector combinations one by one manual, but i need 1000-5000 point vector combinations. Does anybody have an idea how i can import this point vector combination in NX ? I have already measured my kinematic in Matlab. My vector consist out of 2 points.
Thank you guys.
Sincerly Rick